Away Arming the security system.
Whilst the status bar is displaying the message “Area Ready” tap the “Away Icon”, this will arm the security system fully.
The system will not arm if the status bar is displaying “Not Ready”, all sensors must be closed and not activated, check around the building to make sure no doors are open as reed switches may keep the alarm system in the "Not Ready" state.
Stay Arming the security system.
Whilst the status bar is displaying the message “Area Ready” tap the “Stay Icon”, this will partially arm the security system. Predetermined sensors will be isolated, and all remaining sensors will be active. This will need to be setup by your installer at the time off installation.
Disarming the security system.
To disarm the security system, tap the “Off Icon”, a pin pad will display, enter a valid pin code.
User Menu
Tap Menu > Control > Users > Select user to modify > follow prompts
A user is a person that has been allocated a PIN code to arm and disarm areas within the security system. A standard user has the ability to change their pin code, whilst a master user has the ability to create, delete and modify all
Change Name – Type name of user
Change Code – Select new user pin code
Configure Account – User authority level and Area control (only if required)
Delete User – Remove user pin from system
Modify user pin code (EG: user 1)
Menu > Control > Users > (Master pin code or installer pin code)
Select user 1
Change Code > Type new pin code > Enter
Home to exit
Create new user ( EG: user 2)
Menu > Control > Users > (Master pin code)
Select user 2
Create Code > Type new pin code > Enter
Change Name > Type new user name > Enter
Home to exit
Delete user (EG: user 2)
Menu > Control > Users > (Master pin code)
Select user 2
Delete User
Home to exit
Selected zones (sensors) within the security system can be bypassed (isolated) manually. A bypassed zone is not capable of activating an alarm, as it is temporarily removed from your system. All bypassed zones are reset and cleared from memory when the security system is next armed / disarmed.
Controls Menu
Tap Menu > Controls > Zones to access the following features located within the control menu.
After Smoke Detectors activate, they will need to be reset. In order to do this, you will need to do the following: Go to Menu > Smoke Reset. After pressing this, the smoke detectors will be reset.